CHAIR LIFT |
||
|
||
|
When working on a chair lift always disconnect the charge transformer from the mains and only reconnect when the chair lift is fully working. The board is sensitive to static charge. To avoid damage, touch a metal surface on the lift to discharge yourself of static charge but do not touch the IC chips. Please handle the board with care. Do make sure you double check the connections to the motor and battery before switching on. Power up delay. |
|
|
|
When the board is first powered there is a 3 second delay. If either the UP/DOWN controls are enabled the chair lift will not move until the command is removed, then the chair lift will work. This is a safety feature, it stops the chair lift moving 0.5 seconds after the power is applied and the UP/Down controls are enabled. |
Chair lifts ' control and operation delay - The chair lift is operated by pressing the UP/DOWN control, it will bleep then 0.5 seconds later it will start off. If a change of direction is initiated while running, the lift will take 3 seconds to restart after it has stopped. Charger alarm and Battery capacity indication The board is fitted with LEDs and a bleeper to indicate various functions or faults. Bleeping when the chair lift stops - The chair lift, on reaching an end stop, will check that the battery charger supply is switched on. If not is not switched on, it will sound its’ bleeper for 20 seconds. After the 20 seconds, the bleeper will stop. Extended bleep when the chairlifts start - The capacity of the batteries has reduced to 30%. This has occurred because of the following reasons 1. Batteries have not been charged. 2. Heavy use of chair lifts. 3. The batteries are not holding their charge due to age. 4. A cell has become damaged due to age. |
|
| keyconsumer.com / disability accessibility / CHAIR LIFT | ||